Installation Guide For PTC CREO

First Open ISO file of CREO.

Open command prompt and type "ipconfig/all".

Note physical address as per below screen shot.

Now open with ptc_licfile.dat in Notepad.

Now replace physical address as per below.

And than save the file.

Next create a folder with name of PTC in C:\Program Files location. And copy ptc_licfile.dat file in that location.

Now run setup of PTC CREO.

As per below screen shot enter location of licence file.

After finish setup. Open patch file as per below.

Now follow below screen shot.

Now repeat below step again.

Now enjoy.

Comments

Difference Between : IC and EC Engine

Difference between internal combustion engine & external combustion engine is given below:

Comparison between : Otto & Diesel Cycle

Comparison of Otto and Diesel cycle is given below:

Difference Between : EN8 & MS Material

What is the difference between EN8 and MS material? Answer : EN 8 Material MS Material EN 8 material has higher tensile strength. MS material has comparatively low tensile strength. EN 8 material applicable when high strength required. MS material is applicable when high strength not required. EN 8 material contain 0.4% C MS material contain up to 0.25% C EN 8 material is use when other heat treatment process is carried out on it. MS material is use when no need of other heat treatment process on it. EN 8 material can use instead of MS material. MS material can not use instead of EN 8 material. Material is more expensive then MS. Material is less expensive then EN 8. Let me know if there is a addition of point or correction in any point.

Mechanical Engineering & Documents

Search This Blog