Create Surface with Extrude Feature

From Extrude feature we can create solid as well as surface part.

Here we are going to make surface part using Extrude Feature.

Fist of all make sketch as per solid part.

Here you can make open sketch for making surface only.

After click on OK you have to select Extrude as surface option as shown below.

You can also select this option before creating a sketch in Extrude Feature.

Now final you can click on OK. Your surface will created.

Enjoy 😃

Next lesson - Revolve Feature - PTC Creo

Previous lesson - Extrude with Cut Feature

Main Page - PTC CREO

To improve our knowledge then don't forget to give comment.

Also, give your suggestion addition or correction in detail.

Comments

Difference Between : IC and EC Engine

Difference between internal combustion engine & external combustion engine is given below:

Comparison between : Otto & Diesel Cycle

Comparison of Otto and Diesel cycle is given below:

Difference Between : EN8 & MS Material

What is the difference between EN8 and MS material? Answer : EN 8 Material MS Material EN 8 material has higher tensile strength. MS material has comparatively low tensile strength. EN 8 material applicable when high strength required. MS material is applicable when high strength not required. EN 8 material contain 0.4% C MS material contain up to 0.25% C EN 8 material is use when other heat treatment process is carried out on it. MS material is use when no need of other heat treatment process on it. EN 8 material can use instead of MS material. MS material can not use instead of EN 8 material. Material is more expensive then MS. Material is less expensive then EN 8. Let me know if there is a addition of point or correction in any point.

Mechanical Engineering & Documents

Search This Blog